HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER 매뉴얼 - 페이지 18

{카테고리_이름} HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER 24 페이지. Intervideo ã¥â®â¶ã¥âºâ­ã¥â½â±ã©â„¢â¢ ã¥â¿â«ã©â‚¬å¸ã¥â€¦â¥ã©â€”â¨ã¦å’‡ã¥ââ€”
HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER에 대해서도 마찬가지입니다: 사용자 설명서 (37 페이지), 지원 매뉴얼 (27 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (8 페이지), 시작하기 매뉴얼 (2 페이지), 중요 정보 (1 페이지), 중요 정보 (1 페이지), 중요 공지 사항 (1 페이지), 보충 설명서 (1 페이지), 지원 매뉴얼 (29 페이지), 매뉴얼 (8 페이지)

페이지 인쇄
HP -380467-003 - COMPAQ PRESARIO C300 C500 C700 F500 F700 LAPTOP CHARGER 매뉴얼
8 Place the second hard disk drive inside the chassis
and align it with the screw holes (P) on the front of
the chassis. Use four regular 6/32 x ¼-inch screws
(not included) to secure the hard disk drive to the
front of the PC. Tighten the screws from the front of
the PC chassis into the drive.
9 Place the hard disk drive bracket over the new
second hard disk drive, align the four tabs with the
holes on the front of the chassis, and then slide the
bracket toward the bottom of the chassis until it
snaps into place (Q).
14
Upgrading and Servicing Guide
Q
10 Attach the two screws to the hard disk drive
bracket (R).
11 Replace the hard disk drive. See "Replacing a Hard
Disk Drive" on page 11.
12 Connect the end of the data cable to the
motherboard:
•
For Serial ATA drives, plug the free end of the
narrow data cable from the second hard disk
drive to the motherboard connector labeled
SATA2 and plug the narrow data cable from
the primary hard disk drive to the motherboard
connector labeled SATA1.
•
For Parallel ATA drives, connect the data
IDE cable labeled To CPU to the motherboard
connector Primary.
13 Replace the front panel. See "Replacing the Front
Panel" on page 3.
14 Complete the procedures to replace the side panel,
and to close the PC. See "Opening and Closing the
PC" on page 1.
R