HP 124708-001 - ProLiant Cluster - 1850 구현 매뉴얼 - 페이지 32

{카테고리_이름} HP 124708-001 - ProLiant Cluster - 1850에 대한 구현 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 124708-001 - ProLiant Cluster - 1850 35 페이지. Proliant essentials foundation pack installation guide
HP 124708-001 - ProLiant Cluster - 1850에 대해서도 마찬가지입니다: 오류 방지 매뉴얼 (12 페이지), 기술 백서 (12 페이지), 펌웨어 업데이트 (9 페이지), 개요 (20 페이지), 구현 매뉴얼 (26 페이지), 소개 매뉴얼 (22 페이지), 문제 해결 매뉴얼 (18 페이지), 구현 매뉴얼 (11 페이지), 설치 매뉴얼 (2 페이지)

페이지 인쇄
HP 124708-001 - ProLiant Cluster - 1850 구현 매뉴얼
Issue 20
Adding an EISA fibre channel controller
Description
Solution
With the server shut down and power removed from the server, install the EISA
fibre channel controller in the server by following the procedures detailed below
in the "Solution."
To install the controller:
1. Run the System Configuration Utility to add the controller and configure
changes to system BIOS.
2. Restart the server.
3. Start the hardware wizard by right clicking on My Computer | Properties |
Hardware.
4. Select Add/Troubleshoot a Device. No devices will be found.
5. Select Add New Device from the Choose Hardware Device screen.
6. Select No, I want to select hardware from a list.
7. Select SCSI and RAID Controllers.
8. Select HP and HP Fibre Channel Host Controller (non PnP).
9. Click Next | Finish.
10. Restart the server.
To load the driver:
After the restart completes, the Found New Hardware wizard will display.
This process resolves the device listed as Unknown Device under the Device
Manager tree. This Unknown Device, the HP Fibre Channel Controller /E,
requires the CPQFCALM.SYS driver
NOTE
The device HP Fibre Channel
Host Controller (non PnP),
displayed under Device Manager
with a yellow exclamation point,
can now be removed from the
Device Manager tree.
.
32