Miele T 1303 VENT ED DRYER - OPERATING 기술 정보 - 페이지 2
{카테고리_이름} Miele T 1303 VENT ED DRYER - OPERATING에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1303 VENT ED DRYER - OPERATING 3 페이지. Washer/dryer stand
Miele T 1303 VENT ED DRYER - OPERATING에 대해서도 마찬가지입니다: 사용 설명서 (41 페이지)
페이지 인쇄
Washer
Stand
Washer
Stand
Note: The washer/dryer stand is designed for use with washers and dryers only. Use for any other
purpose may result in damage to the machine or personal injury.
DO NOT USE OR PLACE A STACKED WASHER AND DRYER ON THIS STAND!
Carry out the following steps prior to installing the stands.
Drawer Removal
Pull the drawer out all the way. Lift upward to release and remove see Fig. 2.
Rear Panel Removal
Remove the rear panel screws (Torx T20) and remove the rear panel, see Fig. 3
Leveling
The stands must be leveled prior to installing the washer and dryer. Place the stands into their locations see
Fig4. Adjust the feet until the stands are level. Tighten the counter nuts.
Note: The studs for the washer are larger (17mm) than the studs for the dryer (13mm)