Miele T 1303 VENT ED DRYER - OPERATING Технічна інформація - Сторінка 2
Переглянути онлайн або завантажити pdf Технічна інформація для Сушарка Miele T 1303 VENT ED DRYER - OPERATING. Miele T 1303 VENT ED DRYER - OPERATING 3 сторінки. Washer/dryer stand
Також для Miele T 1303 VENT ED DRYER - OPERATING: Інструкція з експлуатації Посібник з експлуатації (41 сторінок)
Друкувати сторінку
Washer
Stand
Washer
Stand
Note: The washer/dryer stand is designed for use with washers and dryers only. Use for any other
purpose may result in damage to the machine or personal injury.
DO NOT USE OR PLACE A STACKED WASHER AND DRYER ON THIS STAND!
Carry out the following steps prior to installing the stands.
Drawer Removal
Pull the drawer out all the way. Lift upward to release and remove see Fig. 2.
Rear Panel Removal
Remove the rear panel screws (Torx T20) and remove the rear panel, see Fig. 3
Leveling
The stands must be leveled prior to installing the washer and dryer. Place the stands into their locations see
Fig4. Adjust the feet until the stands are level. Tighten the counter nuts.
Note: The studs for the washer are larger (17mm) than the studs for the dryer (13mm)