Miele T 1526 운영 매뉴얼 - 페이지 21

{카테고리_이름} Miele T 1526에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1526 28 페이지. Vented dryer
Miele T 1526에 대해서도 마찬가지입니다: 운영 매뉴얼 (28 페이지), 기술 정보 (42 페이지)

페이지 인쇄

Exhaust venting

The moist air from the dryer must be

vented to the outside.

The appliance should not be vented

into a chimney, a wall, a ceiling, or

any concealed spaces of the building.

When installing, try to avoid:

- very long venting systems

- too many bends or angles

- tight corners

otherwise . . .

. . . the drying results will be affected,

. . . drying will take longer and use more

energy.

Materials suitable for venting:

– rigid metal pipe

– flexible metal pipe

To prevent the risk of fire, do not

use vinyl or foil ducting for venting.

Install the venting in such a way that

the expelled air cannot be drawn

back into the machine.

Do not vent the dryer into a flue used

by gas or fuel boilers or heaters.

A vent connector is included with the

machine. It should be pressed into the

vent outlet and will simplify the connec-

tion of the exhaust pipe.

Before installation, disconnect the

tumble dryer from the electrical sup-

ply (unplug from the wall socket, or

turn off the circuit breaker.

Installation at the rear

The machine comes supplied with

the connector installed on the rear

exhaust port.

INSTALLATION INSTRUCTIONS

Installing the connector on the left

side of the machine

Remove the cap covering the ex-

haust part as follows:

– Insert a thin screwdriver into the slot

by the retaining hook. Press the hook

gently upwards.

At the same time turn the cap

counterclockwise.

In the same way remove the vent

socket from the rear exhaust port.

Secure into the side port by pressing

it in and turning it clockwise.

Seal the rear exhaust port using the

cap.