Miele T 1526 운영 매뉴얼 - 페이지 22
{카테고리_이름} Miele T 1526에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miele T 1526 28 페이지. Vented dryer
Miele T 1526에 대해서도 마찬가지입니다: 운영 매뉴얼 (28 페이지), 기술 정보 (42 페이지)
페이지 인쇄
INSTALLATION INSTRUCTIONS
The shorter the exhaust ductwork, the
more efficient the dryer will run. Ex-
pelled air is slowed down in the ducts
due to friction against the inner walls.
The shorter and smoother the inner
walls are, the less friction will be cre-
ated.
An elbow or bend creates more friction
than a straight duct. An Additional Duct
Length Factor must therefore be added
for each elbow or bend used (see
Table I). This factor expresses the re-
sistance of the bend in terms of a
length of straight duct.
The Additional Duct Length Factor is
then added to the actual duct length to
give the Effective Duct Length.
A larger diameter duct also helps to re-
duce friction. Duct diameter should
therefore be increased for longer duct
runs.
Tabel I
Type of bend
Flexible metal duct
Smooth metal duct
Elbow 90° sharp; no radius
Concertina bend
Wall vent kit with louvres, or window vent kit
Wall vent kit with flap, or window vent kit
Exhaust connection, left side
22
To calculate the Effective Duct Length.
Measure the actual straight duct
length needed.
Establish the number of elbows or
bends necessary, noting the type of
bend, angle and radius involved.
(see Table I).
Add the Addiditional Duct Length as
specified in Table I to the actual duct
length to get the Effective Duct
Length.
The necessary duct diameter can
then be found in Table II.
Note:
Drying times and energy consumption
remain unaltered for 4'' duct up to a
total length of 26'.
Longer ducts may lead to slight in-
creases in drying times and energy
consumption but will not impair the
function of the machine as long as the
necessary duct diameter is used (see
Table II).
Angle
Radius in inches
90°
up to 16''
45°
up to 16''
90°
90°
90°
Additional duct
length in inches
4''
8''
20''
12''
14''
90''
28''
142''
99''
193''