HP 23-C130 빠른 설정 매뉴얼 - 페이지 17

{카테고리_이름} HP 23-C130에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 23-C130 25 페이지. Quick setup guide

Keyboard and mouse (wireless)

Symptom

Possible solution

Wireless keyboard

●

or mouse does not

work or is not

detected.

●

The receiver, wireless keyboard, and wireless mouse shown in the following illustrations

are examples; your models might vary. IMPORTANT: During these steps, place the

wireless keyboard and wireless mouse on the same level as the receiver, within 30 cm (12

inches) of the receiver, and away from interference from other devices.

Ensure that you are using the wireless keyboard or wireless mouse within range of the

receiver, approximately 3 meters (10 feet) for normal use, and within 30 cm (12

inches) during initial setup or for re-synchronization.

Ensure that the mouse is not in Suspend mode, which occurs after 20 minutes of

inactivity. Click the left mouse button to reactivate it.

Replace the batteries in the keyboard and mouse.

Re-synchronize the keyboard and mouse to the receiver using the following steps.

Unplug the receiver from a USB connector on the computer, and then reconnect it.

Your computer model might have a connector dedicated to the receiver. If you have a

choice, use a USB connector on the front of the computer.

Check that the mouse is on (A), and push and hold the Connect button (B) on the

underside of the mouse for 5 to 10 seconds until the LED on the receiver lights or

stops flashing. The receiver connection session times out after 60 seconds. To ensure

that the connection was established, and that the receiver did not time out instead,

move the mouse and check for response on the screen.

Off

Connect

After the mouse connection is established, continue by using the steps that follow to

repeat the procedure for the keyboard.

Push and hold the Connect button (C) on the underside of the keyboard for 5 to 10

seconds until the LED on the receiver lights or stops flashing.

Keyboard and mouse (wireless)