HP 3000 Series 설치 매뉴얼 - 페이지 33

{카테고리_이름} HP 3000 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 3000 Series 42 페이지. 9x9 to k class conversion
HP 3000 Series에 대해서도 마찬가지입니다: 매뉴얼 (25 페이지), 업그레이드 매뉴얼 (19 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

Series 44/48 to 58 Memory Upgrade

CHANGING THE NAMEPLATE

This procedure describes replacing the Series 44/48 nameplate with a Series 58 nameplate. A flatblade screwdriver is

required for this procedure.

I; Use the key to unlock the front panel. Swing the panel open to the right.

2. Unscrew the two nuts on the top back of the nameplate.

3. From the back of the nameplate, use the flatblade screwdriver to pry the adhesive-backed nameplate from the panel.

4. Remove the old adhesive from the panel before installing the new nameplate.

5. Remove the protective backing from adhesive on the back side of the new nameplate.

6. Position the new nameplate so that the two small screws through the holes in the panel.

7. Reinstall the two nuts.

NOTE

Ensure that the RFI fingers on the front and back panels make complete contact with the RFI brackets around the

card cage. See Figure 2-5

RFI Brackets

Figure 2-5. Series 58 - Back View (RFI Brackets)

8. Secure with the key.

2-13