HP 800 Series 설치 매뉴얼 - 페이지 28

{카테고리_이름} HP 800 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 800 Series 34 페이지. Version a.01.08
HP 800 Series에 대해서도 마찬가지입니다: 릴리스 노트 (19 페이지)

Troubleshooting

Solving Basic Problems

If you need to recover the online User's Guide

If you have deleted the online User's Guide but would like to access it, you can

restore it from the Recovery CD-ROM.

Run:

omnibook\hputil\disk1\setup.exe.

If the OmniBook doesn't turn on with a fresh battery

If you replaced the battery after the OmniBook turned off due to a low battery,

either plug in the ac adapter—or turn off the OmniBook, then hold

the On/Off key (

F4+ON

If your password doesn't work

Check whether Num Lock is off. Try changing it.

If you've forgotten your password, have your OmniBook at hand and call

Hewlett-Packard at the phone number in the Service and Support booklet.

If the OmniBook beeps repeatedly

If two beeps occur every 10 seconds or so, battery power is critically low and

less than 2 minutes of operation remain. Plug in the ac adapter—or turn off the

OmniBook and insert a fresh battery.

If the computer seems slow

Check that Cache is enabled (in the System Configuration Utility, open the

System menu and check Enable Cache).

You might need to install more RAM. The memory-expansion boards are HP

part numbers F1167A (8 MB), F1168A (16 MB), and F1169A (32 MB).

If you cannot install Windows NT 3.51

In the System Configuration Utility, under the System menu, Boot Devices,

enable the checkbox Force PCI Bridge Configuration.

1-28

) to turn it on.

and press