HP 800 Series 설치 매뉴얼 - 페이지 27

{카테고리_이름} HP 800 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HP 800 Series 34 페이지. Version a.01.08
HP 800 Series에 대해서도 마찬가지입니다: 릴리스 노트 (19 페이지)

If the OmniBook doesn't reboot successfully (Windows for Workgroups)

If your operating system is MS-DOS or Windows for Workgroups

If no text is displayed, or if the system stops before you see any text about

MS-DOS, the OmniBook might require service. Try rebooting again. You can try

to start the System Configuration Utility (press F2 during reboot), then select

Factory Default Settings from the Default menu, and then select Save from the

Exit menu.

If you see error messages during startup, but Windows starts or you get an

MS-DOS prompt, exit Windows (if necessary), and type scandisk to fix

problems with drive C. Then press

"MS-DOS Startup Menu," press

command to find where the problem occurs. Repair or restore the necessary

files as indicated.

If you see text about MS-DOS but things stop before Windows starts or before

you get an MS-DOS prompt, insert the Support Utility disk or other boot disk in

the floppy drive, then press

the System Configuration Utility must have System, Boot Devices set to boot

FDD First.) If the OmniBook doesn't reboot from a floppy boot disk, the

OmniBook probably requires service.

If it reboots, type dir c: to see if drive C contains valid files. Then try the

following:

If drive C has valid files, try typing these commands:

c:\dos\scandisk (to repair any defects)

sys a: c: (to restore MS-DOS boot files).

Try typing each of these commands to see if it fixes the problem:

fdisk /mbr (to repair only the boot sector of drive C) and

c:\dos\scandisk (to repair any file defects).

Last resort: The following commands delete all files on drive C, so try to

back up your data files. You must reinstall your files after running these

commands:

fdisk (to verify partitions on drive C)

Then restore the operating system and the special drivers and software from

the Recovery CD—see page 1-19.

to reboot—but at the

CTRL+ALT+DEL

and step through each startup

F8 ENTER

to reboot from drive A. (Note that

CTRL+ALT+DEL

Troubleshooting

Solving Basic Problems

1-27