Burk Plus-X RP-8 설치 및 운영 매뉴얼 - 페이지 3
{카테고리_이름} Burk Plus-X RP-8에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Burk Plus-X RP-8 9 페이지.
페이지 인쇄Introduction
The Plus-X RP-8 Adapter connects directly to Sine Systems RP-8 Interface Panels to allow a fast, easy
upgrade to the ARC Plus Remote Control. The Plus-X RP-8 Adapter communicates with the ARC Plus
via LAN/WAN, allowing installation anywhere a network connection is available.
The Plus-X RP-8 Adapter is part of the Plus-X family of Ethernet I/O products designed for the ARC Plus.
Installation Note
Even though you may operate the ARC Plus and Plus-X RP-8 Adapter on different subnets, Burk
Technology strongly recommends installing the Plus-X RP-8 Adapter on the same LAN as the ARC Plus.
In a network failure, an ARC Plus can only continue to monitor and control a Plus-X device on the same
LAN. If the network link between the units is not available, ARC Plus macros, alarm monitoring and
telephone control will be unavailable for the Plus-X device.
Before you Begin
Before installing the Plus-X RP-8 Adapter, please have the following network settings ready:
A static IP address for the Plus-X RP-8 Adapter
The IP address of your ARC Plus
The subnet mask and gateway address for your LAN
Compatibility
Before installing the Plus-X RP-8 Adapter , please verify that the ARC Plus firmware, AutoPilot software
and AutoLoad Plus software versions are current. Updates are available at www.burk.com. The
following are minimum software and firmware requirements
Software
ARC Plus firmware
AutoLoad Plus software*
AutoPilot® 2010 software
* Please download the current Plus-X RP-8 Adapter AutoLoad definition XML file from www.burk.com.
"Installing Plus-X Definition Files" can also be downloaded from www.burk.com.
The onboard web interface is compatible with Internet Explorer version 8 or newer, Firefox, Chrome,
and other modern web browsers.
Plus-X RP-8 Adapter Installation and Operation Manual Rev B
Version
2.1.0, 2.3.0 recommended
2.0.0, 3.1.0 recommended
2.5.0, 2.9.16 recommended
1