ALLNIC AUDIO H-1202 소유자 매뉴얼 - 페이지 7

{카테고리_이름} ALLNIC AUDIO H-1202에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALLNIC AUDIO H-1202 11 페이지. Phono–stage preamplifier

To turn on the H-1202, press in the button switch on the left front panel. Pressing the power button again will power

down the H-1202 (See Figure 2).

OPERATION

The H-1202 has a "soft start". After pushing in the power button, the H-1202 will take about 40 seconds to be ready

for play. Each time the H-1202 is powered on, the orange light on its front panel above the power button will

illuminate. If the mute button is in the "on" position (button "out" – not depressed) when you power on the H-1202,

the light above the mute button will illuminate red and stay red after the soft start period. If the mute button is

depressed (mute off), when you power on the H-1202, the mute light will first glow red, and after the soft start

period will change to orange.

SPECIFICATIONS FOR THE ALLNIC AUDIO H-1202 PHONO-STAGE PREAMPLIFIER

Inputs:

Output:

Ground:

Frequency (RIAA):

Voltage Gain:

Input Impedance:

Maximum Input Voltage

(MM, non-clipping):

THD

(Total Harmonic

Distortion):

Output Impedance:

S/N Ratio:

Power Consumption:

Tubes:

One (1) pair Moving Coil (MC) unbalanced (RCA)

One (1) pair Moving Magnet (MM) unbalanced (RCA)

One (1) pair x unbalanced (RCA)

Two (2) x screw type terminal

20Hz ~ 20KHz (±0.3db)

MM: +38db (1KHz)

MC: Variable: +22dB, +26dB, +28dB, +32dB (1Khz)

MC up to 280Ω

MM 47kΩ

20Hz / 30mV

100Hz / 60mV

1KHz / 300mV

10KHz / 500mV

Less than 0.3% (1KHz, Output 1V)

1.2KΩ (on-off method)

-68db (CCIR, 1KHz)

20W / 220V @ 60Hz

E180CC - New old stock -

approximately electrically (not sonically) equivalent: CV8431, 7062,

5965, 12AV7, 6414, 6829;