ALLNIC AUDIO H-1202 Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач ALLNIC AUDIO H-1202. ALLNIC AUDIO H-1202 11 сторінок. Phono–stage preamplifier
Друкувати сторінку
To turn on the H-1202, press in the button switch on the left front panel. Pressing the power button again will power
down the H-1202 (See Figure 2).
OPERATION
The H-1202 has a "soft start". After pushing in the power button, the H-1202 will take about 40 seconds to be ready
for play. Each time the H-1202 is powered on, the orange light on its front panel above the power button will
illuminate. If the mute button is in the "on" position (button "out" – not depressed) when you power on the H-1202,
the light above the mute button will illuminate red and stay red after the soft start period. If the mute button is
depressed (mute off), when you power on the H-1202, the mute light will first glow red, and after the soft start
period will change to orange.
SPECIFICATIONS FOR THE ALLNIC AUDIO H-1202 PHONO-STAGE PREAMPLIFIER
Inputs:
Output:
Ground:
Frequency (RIAA):
Voltage Gain:
Input Impedance:
Maximum Input Voltage
(MM, non-clipping):
THD
(Total Harmonic
Distortion):
Output Impedance:
S/N Ratio:
Power Consumption:
Tubes:
One (1) pair Moving Coil (MC) unbalanced (RCA)
One (1) pair Moving Magnet (MM) unbalanced (RCA)
One (1) pair x unbalanced (RCA)
Two (2) x screw type terminal
20Hz ~ 20KHz (±0.3db)
MM: +38db (1KHz)
MC: Variable: +22dB, +26dB, +28dB, +32dB (1Khz)
MC up to 280Ω
MM 47kΩ
20Hz / 30mV
100Hz / 60mV
1KHz / 300mV
10KHz / 500mV
Less than 0.3% (1KHz, Output 1V)
1.2KΩ (on-off method)
-68db (CCIR, 1KHz)
20W / 220V @ 60Hz
E180CC - New old stock -
approximately electrically (not sonically) equivalent: CV8431, 7062,
5965, 12AV7, 6414, 6829;
7