Allo RemoteControl APRIMATIC UNICO RR-SE 지침
{카테고리_이름} Allo RemoteControl APRIMATIC UNICO RR-SE에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Allo RemoteControl APRIMATIC UNICO RR-SE 2 페이지.
![Allo RemoteControl APRIMATIC UNICO RR-SE 지침](/uploads/products/server2/347082/347082.jpg)
INSTRUCTIONS
APRIMATIC UNICO RR-SE Receiver
Enabling button (See Fig.4) Using the jumpers JP5-8, you can select which receiver output channel
and, therefore, which remote control button, will enable the output signal. This selection is made by
closing just one of the jumpers present, following the scheme indicated below:
JP5 – Channel 1 - Button 1 / JP6 – Channel 2 - Button 2 JP7 – Channel 3 - Button 3 / JP8 – Channel 4
- Button 4
Enabling button row (See Figures 5 and 6):
The receivers may be used with 2-, 4- or 14-button remote controls. If you use it with a 14-button
remote control, you can use the jumpers JP3 and JP4 to define which row of buttons the receiver must
respond to, following the scheme indicated below:
JP3 – JP4 open: row 1 (Buttons 1-4) JP3 closed: row 2 (Buttons 5-8) JP4 closed: row 3 (Buttons 9-12)
JP3 – JP4 closed: row 4 (Buttons 13-14)
8
Visit our website: www.Alloremotecontrol.com