Allo RemoteControl APRIMATIC UNICO RR-SE Instructions

Browse online or download pdf Instructions for Remote Control Allo RemoteControl APRIMATIC UNICO RR-SE. Allo RemoteControl APRIMATIC UNICO RR-SE 2 pages.

Print Page

INSTRUCTIONS

APRIMATIC UNICO RR-SE Receiver

Enabling button (See Fig.4) Using the jumpers JP5-8, you can select which receiver output channel

and, therefore, which remote control button, will enable the output signal. This selection is made by

closing just one of the jumpers present, following the scheme indicated below:

JP5 – Channel 1 - Button 1 / JP6 – Channel 2 - Button 2 JP7 – Channel 3 - Button 3 / JP8 – Channel 4

- Button 4

Enabling button row (See Figures 5 and 6):

The receivers may be used with 2-, 4- or 14-button remote controls. If you use it with a 14-button

remote control, you can use the jumpers JP3 and JP4 to define which row of buttons the receiver must

respond to, following the scheme indicated below:

JP3 – JP4 open: row 1 (Buttons 1-4) JP3 closed: row 2 (Buttons 5-8) JP4 closed: row 3 (Buttons 9-12)

JP3 – JP4 closed: row 4 (Buttons 13-14)

Visit our website: www.Alloremotecontrol.com