Allo RemoteControl APRIMATIC UNICO RR-SE Instructions - Page 2
Browse online or download pdf Instructions for Remote Control Allo RemoteControl APRIMATIC UNICO RR-SE. Allo RemoteControl APRIMATIC UNICO RR-SE 2 pages.
Print Page
INFORMATION: The receiver may also receive commands from 2- and 4-button remote controls
(TR2 and TR4) but only if JP3 and JP4 are left open
Procedure for self-teaching of the first remote control:
1. Power up the receiver.
2. Make sure that the memory is completely free (10 consecutive beeps); if not, delete the
memory.
3. Press all the buttons on the first remote control you want to add at the same time (2 buttons
for TR2 units, 4 buttons for TR4 units) until both the LED and the buzzer come ON (continuous
beeping) to inform you that the self-teaching stage is running.
4. Now press any key on the transmitter.
5. The LED and the buzzer go OFF briefly and then come back ON, confirming the self-teaching
of the remote control within the receiver memory.
Procedure for self-teaching of other remote controls
When the self-teaching of the first remote control is completed, while the signal is still ON, you
can add other remote controls by repeating steps 3 and 4. Afterwards, you can start the remote
control saving procedure again by pressing, at the same time, all the buttons on a TX which has
already been saved: the buzzer will sound and you can now add extra remote controls by
repeating steps 3 and 4