Allo RemoteControl NICE TT1N 지침 - 페이지 3
{카테고리_이름} Allo RemoteControl NICE TT1N에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Allo RemoteControl NICE TT1N 3 페이지.
페이지 인쇄
Programming the "Working time"
8. Press and hold down button ■ of a previously memorized transmitter until you hear a beep (after
about 5 seconds) then release it.
9. Press key ■ again until you hear 4 short beeps (after approx. 5 seconds), then release
10.
Press keys ▲ (or ▼)¸ in order to begin the manoeuvre and start up the time counting
phase.
11.
Wait for the motor to finish the manoeuvre and after a few seconds press key ■ to stop
the time count.
12.
Three beeps will indicate the new working time has been memorised successfully.
N.B. If the user wishes to reset the factory time of 150 seconds, at point 3 she/he must press key ■
until hearing the first of 3 beeps indicating programming has taken place.
Visit our website: www.Alloremotecontrol.com