Allo.com 2aCP8eL series 빠른 설치 매뉴얼 - 페이지 10
{카테고리_이름} Allo.com 2aCP8eL series에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Allo.com 2aCP8eL series 20 페이지. E1/t1 8 port pri card
페이지 인쇄8 Port PRI Card- Quick Installation Guide
4. Replace the cover to your computer
5. Plug the T1 or E1 equipment cable into the RJ45 port.
Use only shield cables to ensure compliance with the international EMC standards.
3. Software Configuration
3.1 T1/E1 Selection
The 2aCP8eL series cards can be configured for either T1 or E1 mode. The T1/E1 mode may be
specified in the drivers using either the default_linemode= t1 or default_linemode=e1 module
parameter when the drivers are loaded. This will set the mode for all spans on the card.
3.2 E1/T1 mode settings
By default the card is ready to use in E1 mode
E1 Mode
Add "allo4xxp" at the end of /etc/dahdi/modules, so that while starting dahdi driver Allo card
modules will load automatically.
T1 Mode
To configure the PRI card in T1 signaling mode, please add the following line in the relevant files,
www.allo.com
Insert Card
Version 2.1
10