Allo.com 2aCP8eL series Instrukcja szybkiej instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Karta PCI Allo.com 2aCP8eL series. Allo.com 2aCP8eL series 20 stron. E1/t1 8 port pri card

Drukuj stronę

8 Port PRI Card- Quick Installation Guide

4. Replace the cover to your computer

5. Plug the T1 or E1 equipment cable into the RJ45 port.

Use only shield cables to ensure compliance with the international EMC standards.

3. Software Configuration

3.1 T1/E1 Selection

The 2aCP8eL series cards can be configured for either T1 or E1 mode. The T1/E1 mode may be

specified in the drivers using either the default_linemode= t1 or default_linemode=e1 module

parameter when the drivers are loaded. This will set the mode for all spans on the card.

3.2 E1/T1 mode settings

By default the card is ready to use in E1 mode

E1 Mode

Add "allo4xxp" at the end of /etc/dahdi/modules, so that while starting dahdi driver Allo card

modules will load automatically.

T1 Mode

To configure the PRI card in T1 signaling mode, please add the following line in the relevant files,

www.allo.com

Insert Card

Version 2.1