Dialogic IMG 1010 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Dialogic IMG 1010에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialogic IMG 1010 9 페이지. Connecting dc power
Dialogic IMG 1010에 대해서도 마찬가지입니다: 설치 지침 설명서 (6 페이지), 빠른 시작 매뉴얼 (11 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄
Dialogic IMG 1010 설치 지침 매뉴얼

Configure 1010 VOIP Module Resources

1.
The 1010 VoIP module has been configured. The next step is to configure the resources for each
module. If installing VoIP Module 1 then the resources for VoIP module 0 should already be
configured. Below is screen capture of what the resource pane for the existing 1010 VoIP Module
will look like. The next few steps will configure the resources for the module just installed.
2.
Right Click on Facility object and select New Bearer - IP. The VOIP module/resource pane will
get created. See below
3.
Fill in the fields. Below is information on each of the fields.
Module ID - Automatically populated with next available module ID. Can be changed by clicking
in the Module ID field and selecting from drop down menu. Selections are 0 and 1. If ID:0 is
selected in the Module ID field then the VOIP Module 0: Port 0 will automatically be chosen. If
ID:1 is selected then VoIP Module1: Port 0 will be chosen.
Network Interface - The Network Interface field is populated with VOIP Module 1: Port 0 if
Module ID:1 was selected in the Module ID field.
Network IP Address - Network IP address field is automatically populated with the IP address
configured for the VoIP Module selected.
Module Configuration Profile - The Module Configuration Profile field informs the user what
profile is configured. This is taken from the dhcpd.conf file in /etc. This field also informs user
what type of module is installed. (Picasso or BroadCom). This field cannot be changed.
Starting RTP Port - The Starting RTP Port field shows the default port that the RTP stream will
use. To change the Port number click in the field and a range dialog box will appear. The port
number can be changed there. Once the VoIP Module/Resource pane has been committed, the
port cannot be changed. The object would have to be deleted and readded to change the port
number
Fully Qualified Domain Name - The FQDN will be inserted in outgoing SIP messages when
FDQN is enabled in the SIP Profile. See Fully Qualified Domain Name Support for more
information.
Dialogic Corporation
Part # 07-8740-02
Page 8 of 9