Dialogic IMG 1010 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Dialogic IMG 1010에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dialogic IMG 1010 9 페이지. Connecting dc power
Dialogic IMG 1010에 대해서도 마찬가지입니다: 설치 지침 설명서 (6 페이지), 빠른 시작 매뉴얼 (11 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (4 페이지)

Installing 1010 VoIP Module onto 1010 motherboard

Observing proper ESD procedures, remove the 1010 VoIP module from its ESD packaging and

inspect for damage. Pay special attention to the mating connectors.

Position the module over the four standoffs on 1010 Motherboard.

Align the connectors on the 1010 VoIP Module with the connectors on the 1010 Motherboard.

Before pushing the connectors together, ensure the connectors are properly aligned.

Apply pressure with the thumbs and index fingers on the edges of a module forming a window

around the connectors. The level of pressure should not be excessive; it should be enough to

firmly seat the 1010 VoIP module. CAUTION: DO NOT APPLY PRESSURE TO ANY OF THE

COMPONENTS ON THE MODULE

Install the four (4) Phillips pan head screws to secure the module. Do not over-tighten the screws.

(Recommended torque: 4 in-lbs (.34-.56 N-M)).

Once module is securely fastened to the 1010 Motherboard, reinsert the 1010 Motherboard Tray

into IMG chassis. Align the rail on each side of the tray with the guides on the inside of the

docking station.

Verify the ejectors are in the up position. Slide the tray in until the power connectors and signal

connectors initially mate (the ejectors will start to move down). Use ejectors to firmly seat the

1010 Motherboard tray into the IMG chassis.

Cautions:

Do not force the tray into the IMG chassis connectors. If any resistance occurs when mating with

the docking station, slide 1010 Motherboard out and reseat connectors. Using undue force could

damage the unit.

The guides only provide general alignment to the power and signal connectors. The guide pins

on the main board and I/O card are self-aligning and will provide final alignment for the

connectors.

The tray guides also act as the conduit for any Electrostatic Discharge (ESD) as the tray initially

mates with the docking station.

When the tray is seated and the connectors are mated, push the ejectors down and tighten the

captive fasteners. Reconnect power and cabling.

Switch the power to ON (1) at rear of docking station and allow software to load. To configure the

module, start GCEMS and ClientView. See the Dialogic Manuals website located at

http://www.dialogic.com/manuals

Dialogic Corporation

for information on starting GCEMS and ClientView

Part # 07-8740-02

Page 6 of 9