AllPondSolutions 3000PP 매뉴얼 - 페이지 6
{카테고리_이름} AllPondSolutions 3000PP에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions 3000PP 13 페이지. Pond & aquarium
페이지 인쇄INSTALLATION & USE
The All Pond Solutions PP pump range can be used to circulate water, pump to
and from a separate filtration system or water features using suitable flexible
hose (flexible hosing sold separately).
Please read the below instructions carefully before beginning to set up your
pump. DO NOT CONNECT THE UNIT TO THE MAINS UNTIL SET UP IS
COMPLETE AND UNIT IS FILLED WITH WATER.
1. Connect the required attachments - make sure
the O-rings is added to the outlet hosetail (see image
on the right for reference). This will prevent leakage.
2. Connect your outlet pipe to either your filter, water
feature or alternative location. Secure the outlet pipe
using the included nut and ensure this is tight and
secure.
You can add filter foam (sold separately) to the inlet of
the PP. This may slow down your flow rate but will
ensure you pick up larger dirt particles before this
enters your pump/filter system.
3. If you need to connect the inlet pipe you can
remove the front case cap before attaching the hose.