AllPondSolutions CUV-155 매뉴얼 - 페이지 6

{카테고리_이름} AllPondSolutions CUV-155에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AllPondSolutions CUV-155 17 페이지. Pond & aquarium uv steriliser

3. Add ﬁxing brackets to your unit. There should be one at each end of the unit.

You can then use them to secure the unit on ﬂat surface.

3. Clear hosetail - is interchangeable with the black hosetail. It has a spindle

that indicates the ﬂow rate so you can use it on the

inlet/outlet. Sometimes you may notice the spindle

stops rotating, this is okay as long as the water runs

through the unit.

4. Make sure the O-rings are placed smooth side up

to the hosetail (see image on the right for reference).

This will prevent leakage.

5. Pond installation - place your CUV unit at least 2 metres away from pond.

This is to ensure the UV unit cannot fall into the pond. Connect pipework from

feeder pump (not included) to inlet hosetail and secure using clip/clamp.

Connect pipework to hosetail outlet to feed into ﬁltration system (not included)

or return water to pond to ensure this is water tight.

6. Aquarium installation - place your CUV unit securely on a ﬂat surface.

Connect outlet pipework from aquarium pump or external ﬁlter to CUV inlet

hosetail.

Connect pipework to hosetail outlet to return water to aquarium. Secure all

pipework using hose clip/clamp to ensure this is water tight..

5. Connect your CUV to the mains - connect the unit to the mains using a

residual current device (RCD) for additional safety.

6. Switch on your unit at the mains - turn on the operation by switching on the

unit at the mains.