Miller Axcess 300 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Miller Axcess 300에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Axcess 300 48 페이지. Arc welding power source and wire feeder with meters
Miller Axcess 300에 대해서도 마찬가지입니다: 소유자 매뉴얼 (36 페이지), 소유자 매뉴얼 (44 페이지)
페이지 인쇄
3-3. Duty Cycle And Overheating
100% Duty Cycle At 225 Amperes
Continuous Welding
Overheating
3-4. Volt-Ampere Curves
8 0
7 0
6 0
5 0
4 0
3 0
2 0
1 0
0
0
1 0 0
OM-216 967 Page 10
0
15
Minutes
CV MODE
20 0
3 0 0
40 0
A M P E R A G E
60% Duty Cycle At 300 Amperes
6 Minutes Welding
OR
Reduce Duty Cycle
5 00
6 00
Duty Cycle is percentage of 10
minutes that unit can weld at rated
load without overheating.
If unit overheats, thermostat(s)
opens, output stops, and cooling
fan runs. Wait fifteen minutes for
unit to cool. Reduce amperage or
duty cycle before welding.
Y Exceeding duty cycle can
damage
unit
and
void
warranty.
4 Minutes Resting
A/V
duty1 4/95 − 178 651
Volt-ampere curves show minimum
and
maximum
voltage
amperage output capabilities of
unit. Curves of other settings fall
between curves shown.
.
This
volt-ampere
curve
represents the dynamic output
of the unit with a static load.
va_curve1 4/95
and