Miller Spectrum 625 X-TREME 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Miller Spectrum 625 X-TREME에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Spectrum 625 X-TREME 44 페이지. Air plasma cutter
Miller Spectrum 625 X-TREME에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지), 소유자 매뉴얼 (40 페이지)

페이지 인쇄
Miller Spectrum 625 X-TREME 소유자 매뉴얼

4-5. Connecting Gas/Air Supply

Tools Needed:
9/16 in.

4-6. Connecting Work Clamp

2
.
A complete Parts List is available at www.MillerWelds.com
1
1
.
1
2
3
Obtain hose with 1/4 NPT right-
hand thread fitting. Wrap threads
with teflon tape (optional) or apply
pipe sealant, and install fitting in
opening. Route hose to gas/air
supply.
2
3
From Gas/Air
Supply
1
2
Connect work clamp to a clean,
paint-free location on workpiece, as
close to cutting area as possible.
Use only clean, dry air with 90
to 120 psi (621 to 827 kPa)
pressure.
Gas/Air Inlet Opening
Hose
Teflon Tape
805 326-A
Work Clamp
Workpiece
Ref. 803 640-A
OM-237 974 Page 13