aquanta AQ-CA-E300-1 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} aquanta AQ-CA-E300-1에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aquanta AQ-CA-E300-1 12 페이지. Smart water heater controller

Aquanta Installation

Aquanta contains the electronics and sensor connections.

CAUTION:

Turn the electricity to the water heater off

by switching the circuit breaker to the "OFF" position.

This is typically a double breaker for electric water

heaters. Aquanta is intended for use on electrical branch-

circuits of 30 amps or less. Do not connect Aquanta to a

branch circuit that has a circuit breaker larger than 30

amps. The proper amperage of the circuit should be

determined by the labeled wattage of the water heater in accordance with the applicable

National and/or Local electrical codes. For installations requiring protective conduit

covering over the AC power conductors, use only flexible conduit covering. Do not attach

rigid conduit to Aquanta.

TIP: Test that the electricity is off at the water heater using a voltage tester.

1. Using a screwdriver, remove the electrical

cover plate from the top of the water heater.

Remove the wire nuts from the wires and

separate the wires. Remove the ground wire

from the ground screw. Loosen and remove

the cable clamp from the electrical cover plate

by loosening the nut on the underside of the

cover plate. Remove the cover plate from the

cable clamp and the AC Mains supply wires.