Miller XT30 소유자 매뉴얼 - 페이지 27

{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 40 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지)

페이지 인쇄
Miller XT30 소유자 매뉴얼

6-5. Sequence Of Cutting Operation

Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
!
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
.
A complete Parts List is available at www.MillerWelds.com
Pause briefly at end of
cut before releasing trigger.
90
For standard (shielded) cutting, place drag shield on edge
of metal. For extended (non-shielded) cutting, use 1/8 in.
(3.2 mm) standoff distance (dragging tip will reduce tip life).
After cutting arc starts, slowly
start moving torch across metal.
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
Ref. 254 087-A
OM-253 555 Page 23