Miller XT30 소유자 매뉴얼 - 페이지 29
{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 40 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (44 페이지)
페이지 인쇄
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
n = Check
* To be done by Factory Authorized Service Agent
Each
Use
n Gas/Air Pressure
Every
Week
n Shield Cup Shutdown
System
l Damaged Or Unreadable
Every
Labels
3
Months
n l Torch Body, Cable
Every
OR
6
Months
~ Inside Unit
7-2. Overload Protection
.
A complete Parts List is available at www.MillerWelds.com
Z = Change
~ = Clean
n Torch Tip, Electrode,
And Shield Cup
~ Air Filter/Regulator
!
Disconnect power
before maintaining.
l = Replace
l Cracked Parts
n l Gas/Air Hose
1
.
Maintain more often
during severe conditions.
Reference
Section 5-2,
7-6
Section 7-4
Section 7-5,
9
1
Supplementary Protector CB1
CB1 protects unit from overload. If
CB1 opens, unit shuts down.
Reset supplementary protector.
Ref. 251 808-A
OM-253 555 Page 25