Miller XT30 소유자 매뉴얼 - 페이지 28
{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 44 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)
페이지 인쇄
6-4.
Plasma Cutting System Practices
1
3
90
6
1/8 in.
(3.2 mm)
OM-253555 Page 24
�
Complete Parts List is available at www.MillerWelds.com
A complete Parts List is available at www.MillerWelds.com
2
4
7
Wt
The pilot arc starts immediately
when trigger is pressed.
Step 1. Always connect work clamp to a
clean, paint-free location on workpiece, as
close to cutting area as possible.
Step 2. Do not start pilot arc without cutting
as this shortens the service life of the nozzle
and electrode.
Step 3. Maintain approximately a 90° angle
to the workpiece surface for proper cutting
results.
5
Step 4. Sparks should pass through the
workpiece and out the bottom when cutting.
Step 5. If sparks flare back from surface, this
usually is an indication that either travel
speed is too fast or amperage is set too low.
Step 6. When doing extended (non-
shielded) cutting, maintain approximately
1/8 in. (3.2 mm) standoff between electrode
and surface.
Step 7. Do not put pressure on shield when
drag cutting; instead, slide shield along the
8
surface for proper cutting results.
Step 8. Pulling rather than pushing the torch
makes cutting easier. Use a proper guide or
template for accurate cutting operations.
Ref. 254087-A
OM-253555 Page 1