Miller XT30 소유자 매뉴얼 - 페이지 30

{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 44 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)

페이지 인쇄
Miller XT30 소유자 매뉴얼
6-6.

Sequence Of Piercing Operation

1
3
90
5
OM-253555 Page 26
�
Complete Parts List is available at www.MillerWelds.com
2
45
4
The pilot arc starts immediately
when trigger is pressed.
Step 1. Connect work clamp to a clean,
paint-free location on workpiece, as close to
cutting area as possible.
Step 2. Hold torch at approximately 45° to
the workpiece. Raise trigger lock and press
trigger. Pilot arc starts.
Step 3. Rotate torch to upright position ap-
proximately 90° to surface. When arc has
pierced through workpiece, start cutting.
Step 4. Maintain approximately 90° torch po-
sition to surface, and continue cutting.
Step 5. Release trigger. Postflow continues
for approximately 20 seconds after releasing
trigger; arc can be instantly restarted during
postflow by raising trigger lock and pressing
90
trigger.
Ref. 254087-A
OM-253555 Page 1