Miller XT30 소유자 매뉴얼 - 페이지 32

{카테고리_이름} Miller XT30에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30 44 페이지. Air plasma cutting and gouging
Miller XT30에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)

Miller XT30 소유자 매뉴얼
7-2.

Overload Protection

A complete Parts List is available at www.MillerWelds.com
7-3.

Wrapper Removal

A complete Parts List is available at www.MillerWelds.com
Ref. 251808-A
Torx 25
A complete Parts List is available at www.MillerWelds.com
philips head
7-4.

Checking Shield Cup Shutdown System

nutdriver
1
light-duty workclamp
wirecutter
OM-253555 Page 28
Complete Parts List is available at www.MillerWelds.com
Ref. 251808-A
2
1
wrench
crescent wrench
chippinghammer
Ref. 253 554-A
frontcutter
1 Supplementary Protector CB1
CB1 protects unit from overload. If CB1
opens, unit shuts down.
1
Reset supplementary protector.
1 Wrapper
2 Torx Screws (Fine Thread)
Remove Torx screws and slide wrapper off.
1 Torch Shield Cup
Turn Power On and loosen shield cup. If
shutdown system works properly, Cup light
comes on. If not, immediately turn Off power
and have Factory Authorized Service Agent
check unit.
If system works properly, retighten cup and
reset power.
Turn off power, and disconnect in-
put power plug from receptacle or
turn off and lockout/tagout line dis-
connect device before working on
unit.
Significant DC voltage can remain
on capacitors after unit is Off.
Check to see that front panel lights
(LEDs) have stopped flashing and
are off before removing wrapper.
Always
turn
Off
power
changing or checking consum-
ables. Do not overtighten torch
shield cup. Gently finger-tighten
cup onto torch.
Power must be reset whenever the cup
shutdown system is activated.
when