Miller XT30 Kullanıcı El Kitabı - Sayfa 32
Kaynak Sistemi Miller XT30 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Miller XT30 44 sayfaları. Air plasma cutting and gouging
Ayrıca Miller XT30 için: Kullanıcı El Kitabı (40 sayfalar)
Sayfayı Yazdır
7-2.
Overload Protection
A complete Parts List is available at www.MillerWelds.com
7-3.
Wrapper Removal
A complete Parts List is available at www.MillerWelds.com
Ref. 251808-A
Torx 25
A complete Parts List is available at www.MillerWelds.com
philips head
7-4.
Checking Shield Cup Shutdown System
nutdriver
1
light-duty workclamp
wirecutter
OM-253555 Page 28
�
Complete Parts List is available at www.MillerWelds.com
Ref. 251808-A
2
1
wrench
crescent wrench
chippinghammer
Ref. 253 554-A
frontcutter
1 Supplementary Protector CB1
CB1 protects unit from overload. If CB1
opens, unit shuts down.
1
Reset supplementary protector.
1 Wrapper
2 Torx Screws (Fine Thread)
Remove Torx screws and slide wrapper off.
�
1 Torch Shield Cup
Turn Power On and loosen shield cup. If
shutdown system works properly, Cup light
comes on. If not, immediately turn Off power
and have Factory Authorized Service Agent
check unit.
If system works properly, retighten cup and
reset power.
Turn off power, and disconnect in-
put power plug from receptacle or
turn off and lockout/tagout line dis-
connect device before working on
unit.
Significant DC voltage can remain
on capacitors after unit is Off.
Check to see that front panel lights
(LEDs) have stopped flashing and
are off before removing wrapper.
Always
turn
Off
power
changing or checking consum-
ables. Do not overtighten torch
shield cup. Gently finger-tighten
cup onto torch.
Power must be reset whenever the cup
shutdown system is activated.
when