Miller XT30C 매뉴얼 - 페이지 27
{카테고리_이름} Miller XT30C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XT30C 40 페이지.
Miller XT30C에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)
페이지 인쇄
5-3. Sequence Of Piercing Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
90
Rotate torch to upright position
approximately 90
to surface.
When arc has pierced through
workpiece, start cutting.
45
Hold torch at approximately 45
to the workpiece. Raise trigger
lock and press trigger. Pilot arc
90
Maintain approximately 90
torch
position to surface, and continue
cutting.
!
The pilot arc starts immediately
when trigger is pressed.
starts.
Release trigger. Postflow continues for
approx. 20 seconds after releasing trigger;
arc can be instantly restarted during postflow
by raising trigger lock and pressing trigger.
OM-254 449 Page 23
Ref. 254 087-A