Miller 301 146 소유자 매뉴얼

{카테고리_이름} Miller 301 146에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller 301 146 2 페이지.

페이지 인쇄

OWNER'S MANUAL

RCCS-RJ (301 146)

Safety Symbol Definitions

DANGER! − Indicates a hazardous situation which, if not

avoided, will result in death or serious injury. The possible

hazards are shown in the adjoining symbols or explained

in the text.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury. The possible ha-

zards are shown in the adjoining symbols or explained in

the text.

NOTICE Indicates statements not related to personal injury.

Indicates special instructions.

Proposition 65 Warnings

Welding or cutting equipment produces fumes or gases which contain

chemicals known to the State of California to cause birth defects and,

in some cases, cancer. (California Health & Safety Code Section

25249.5 et seq.)

This product contains chemicals, including lead, known to the state of

California to cause cancer, birth defects, or other reproductive harm.

Wash hands after use.

Installation And Operation

The RCCS-RJ (Rotary Current And Contactor Control) is equipped with an RJ plug.

Beware of electric shock from wiring. Shut down welding

power source, and be sure it cannot be accidentally ener-

gized before making remote control connections. Be sure

remote control is turned all the way off before turning on

or off the welding power source.

Wear safety glasses with side shields.

Have only trained and qualified persons install, operate,

or service this unit. Call your distributor if you do not un-

derstand the directions. For WELDING SAFETY and

EMF information, read owner's manual(s).

OM-264 612B

2015−01

RCCS-RJ (Rotary Current

And Contactor Control)

Velcro Straps

Torch

Secure to torch with velcro straps.

RJ Plug

Insert plug into matching receptacle

on welding power source.

Current And Contactor

Control Thumbwheel

Turn thumbwheel clockwise to en-

ergize the welding power source

and increase current level up to that

set on the welding power source

current control.

Turn thumbwheel in the opposite

direction to reduce current output

to zero, and deenergize the welding

power source.

WC0140