Miller Maxstar 161 S 소유자 매뉴얼 - 페이지 27
{카테고리_이름} Miller Maxstar 161 S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Maxstar 161 S 44 페이지. Arc welding power source with auto-line
페이지 인쇄
6-3. Process Selection (STH Model Only)
=Light Off
=Light On
2
3
1
Press
Press
6-4. Process Selection (S Model Only)
2
1
.
A complete Parts List is available at www.MillerWelds.com
4
Press
=Light Off
=Light On
3
1
Press
Press
5
Press
1
Process Selector Button
Use control to select required welding
process. Press Button until LED for
desired process is illuminated.
2
Stick (SMAW)
When selected, Adaptive Hot Start
,Stick Stuck, and DIG circuitry are en-
ergized.
3
Stick 6010 (SMAW)
When selected, Adaptive Hot Start
,Stick Stuck, and DIG circuitry are en-
ergized. Parameters are optimized to
run a 6010 Stick electrode.
1
Process Selector Button
Use control to select required
welding process. Press Button un-
til light (LED) for desired process is
illuminated.
2
TIG Impulse Start
When selected, an impulse HF arc
starting method is activated (see
Section 6-5).
3
Lift-Arc Start
When selected, a TIG arc starting
method in which the electrode
must come in contact with the
workpiece to initiate an arc is acti-
vated (see Section 6-5).
4
Stick (SMAW)
When selected, Adaptive Hot
Start, Stick Stuck and DIG circuitry
are energized.
5
Stick 6010 (SMAW)
When selected, Adaptive Hot Start
,Stick Stuck, and DIG circuitry are
energized. Parameters are opti-
mized to run a 6010 Stick elec-
trode.
OM-275099 Page 23