Miller Maxstar 161 S 소유자 매뉴얼 - 페이지 28

{카테고리_이름} Miller Maxstar 161 S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Maxstar 161 S 44 페이지. Arc welding power source with auto-line

페이지 인쇄

6-5. Lift-Arc And TIG Impulse Start Procedures

Pictorials show Lift-Arc start method − do not

use this method for TIG Impulse starts.

6-6. Accessing Control Panel Menu: TIG−HF (STH Model Only)

USER

REMOTE STD

PPS

OM-275099 Page 24

A complete Parts List is available at www.MillerWelds.com

1 − 2

"Touch"

Seconds

Do NOT Strike Like A Match!

OFF

Trigger Mode Selection:

[REMOTE STD] Remote Standard

Typically used with a remote foot or hand control. REMOTE STD requires

a maintained contact closure to enable weld output. Amperage can be con-

trolled with a remote potentiometer, or it can be set at the control panel.

[REMOTE HOLD] Remote Hold

Remote control required. Allows the operator to weld without holding the

trigger closed. To start the weld, operator presses and releases trigger. To

stop the weld, the operator again presses and releases the trigger. In this

mode, only the output contactor is controlled by the remote control. Amper-

age must be set on the control panel.

[PPS] Pulse Control:

Reduces heat input to minimize distortion and increase travel speed. Set

PPS (pulse per second). The range is OFF−150 PPS. Background Am-

perage and Peak Amperage are not adjustable. Background Amperage

equals 25% of Peak Amperage. Peak Amperage Time equals 40%.

Lift-Arc Start

TIG Electrode

Workpiece

Touch tungsten electrode to work-

piece, hold for 1-2 seconds, slowly

lift electrode, and an arc forms.

Open-circuit voltage maybe present

before electrode touches workpiece.

TIG Impulse

High frequency starts arc when output

is enabled without making contact with

the workpiece. High frequency turns

off when arc is started.

Menu Button

While in the High Frequency (HF)

process, press and hold Menu but-

ton for approximately two seconds

to access Machine Configuration

menus. Use Menu button to cycle

through parameters that can be set.

Parameter Display

Encoder

Rotate Encoder to adjust parame-

ter setting.