Miller S-75SC 소유자 매뉴얼 - 페이지 25

{카테고리_이름} Miller S-75SC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller S-75SC 40 페이지.

SECTION 6 − OPERATION

Power Switch

804 182-B

Jog/Purge Push Button

Pressing the Jog/Purge switch al-

lows the operator to jog wire without

energizing the weld power or gas

valve circuit.

• Jog speed can be adjusted with

the Wire Speed control when the

unit is jogging wire. If equipped

with meters, the unit displays jog

speed while the unit is being

jogged.

• Pressing the Jog/Purge button

also allows the operator to purge

gas lines before welding and to

preset gas pressure at the regu-

lator.

Trigger Hold Switch

Trigger hold allows the operator to

weld without holding the gun trigger.

• To use the trigger hold function,

place the trigger hold switch in the

On position.

• The operator must hold the trig-

ger for a minimum of 2 seconds,

but not longer than 6 seconds be-

fore releasing it. Welding will con-

tinue when the trigger is released.

• To stop welding, press the trigger

again.

Wire Speed Control

Gun Trigger Receptacle

802 828-A

OM-223 605 Page 21