Miller S-75SC 소유자 매뉴얼 - 페이지 26
{카테고리_이름} Miller S-75SC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller S-75SC 40 페이지.
페이지 인쇄6-3. Voltage Control And Digital Meters (For Models With Meters Only)
Notes
OM-223 605 Page 22
1
Voltmeter
The voltmeter displays actual or
preset voltage from the welding
power source through the 14−pin
control cable.
.
Voltmeter will not display actu-
al or preset voltage if voltage
feedback is not provided
1
through the 14-pin control
cable.
2
2
Wire Speed Meter
The wire speed meter is factory set
3
to display inches per minute. If dis-
play of meters per minute is de-
sired, see Section 5-13.
3
Voltage Control
Use control to adjust voltage output
of welding power source.
.
You can adjust the preset volt-
age display on the wire feeder
to match your power source's
display by adjusting P2 on mo-
tor control board PC1. See
Section 7-3 for location of P2.
804 182-A