Miller Spoolmate 150 소유자 매뉴얼 - 페이지 21

{카테고리_이름} Miller Spoolmate 150에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Spoolmate 150 36 페이지.

5-1.

Controls For Millermatic 211

OM-272 384 Page 4

SECTION 5 – OPERATION

SECTION 2

OPERATION

1 Shielding Gas Cylinder

For shielding gas connections, see welding

power source Owner's Manual.

2 Valve

Open valve on cylinder just before welding.

Close valve on cylinder when finished

welding.

3 Process Select Switch

Select the Spool Gun position.

4 Perform Motor Calibration

See the Millermatic 211 Owner's Manual for

Spoolmate Motor Calibration procedure.

5 Trigger

Press trigger to energize welding power

source contactor, start shielding gas flow,

and begin wire feed.

6 Wire Feed Speed Control

Wire feed speed is controlled by welding

power source Wire Speed control (see weld-

ing power source Owner's Manual or door

chart for appropriate setting).

7 Voltage Control

Arc voltage is controlled by welding power

source Voltage control (see welding power

source Owner's Manual or door chart for ap-

propriate setting).

�

Ref. 265 381-A / Ref. 271 714-A

To purge shielding gas line, hold trigger

for three seconds.

OM-272384 Page 17