Miller Spoolmate 150 소유자 매뉴얼 - 페이지 24

{카테고리_이름} Miller Spoolmate 150에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Spoolmate 150 36 페이지.

2-4. Controls For Multimatic 215

5-4.

Controls For Multimatic 215

1 Shielding Gas Cylinder

For shielding gas connections, see welding

power source Owner's Manual.

2 Valve

Open valve on cylinder just before welding

Close valve on cylinder when finished

welding.

3 Process Select Button

Press up and down buttons to select MIG

Aluminum.

4 Perform Motor Calibration

OM-272384 Page 20

See the Multimatic 215 Owner's Manual for

Spoolmate motor calibration procedure.

5 Auto-Set Button

Press button to turn Auto-Set On or Off.

6 Wire/Rod/Tungsten Buttons

Press the Plus (+) or Minus (-) button to se-

lect the size of wire, rod, or tungsten for the

selected process.

�

When MIG Aluminum process is se-

lected, Wire/Rod/Tungsten buttons are

used to select type of spool gun being

used.

7 Material Thickness Buttons

Press the Plus (+) or Minus (-) button to se-

lect material thickness for the selected

process.

8 Display

9 Adjustment Knobs

10 Trigger

Press trigger to energize welding power

source contactor, start shielding gas flow,

and begin wire feed.

Ref. 271491A / 275178A

OM-272 384 Page 7