Miller Spoolmate 150 소유자 매뉴얼 - 페이지 26
{카테고리_이름} Miller Spoolmate 150에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Spoolmate 150 36 페이지.
페이지 인쇄
6-2.
Changing Drive Rolls
tools/
flathead
knife
steelbrush
heavy-duty workclamp
light-duty workclamp
OM-272384 Page 22
8
7
9
philips head
wrench
nutdriver
wirecutter
4
3
2
1
6
5
804 987-A
crescent wrench
chippinghammer
frontcutter
Turn Off power at welding power
source first.
1 Drive Roll Cover
Remove cover.
Changing Push Roll:
To remove push roll:
2 Push Roll Screw
3 Washer
4 Push Roll
Remove screw and washer, and lift out drive
roll.
To install drive roll:
Slide drive roll onto shaft and secure with
washer and screw.
Changing Lower Drive Roll:
To remove drive roll:
5 Lower Drive Roll Screw
6 Washer
7 Lower Drive Roll
8 Drive Roll Key
9 Drive Roll Shaft
Remove screw and washer, and lift out drive
roll. Note: drive roll key will come out with
drive roll.
�
It may be necessary to remove drive
roll side of gun case to change lower
drive roll.
To install drive roll:
Place drive roll key in slot in drive roll shaft.
Line slot in drive roll up with drive roll key,
and slide drive roll onto shaft.
Secure drive roll with washer and screw.
Reinstall gun case, if applicable.
Reinstall drive roll cover.