Miller VL-M4 소유자 매뉴얼 - 페이지 17

{카테고리_이름} Miller VL-M4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller VL-M4 36 페이지. Submerged arc controller for automatic welding

4-3. Connection Diagram

Customer must supply wire drive assembly and drive rolls, gun, welding wire, weld cables, and

Note

flux for the desired application.

17-Pin Shunt

Control Cord

14-Pin Welding

Power Source

Control Cord

Welding Cables

Flux Valve

5-Pin Motor

Control Cord

This unit is supplied with the 5-pin,

14-pin, and 17-pin cords. Select

the proper cord and make each of

the connections shown.

For non-Miller power sources

and wire drive motors, Term-

minal Strip TE2 can be used

for hookup (See Sections 3-9

and 3-10).

Route voltage sense lead through

strain relief on user access hole.

Connect one end to terminal 21 on

TE1 (see Section 4-6). Connect

other end of voltage sensing lead

to the workpiece.

Cord

Voltage

Sensing

Cord

OM-189 530 Page 13