Diamir Experience 06/07 서비스 매뉴얼 - 페이지 6

{카테고리_이름} Diamir Experience 06/07에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamir Experience 06/07 20 페이지. Eagle experience freeride pro

4 DIAMIr

Service Manual for specialist dealers

Mounting binding

3.1

Fix the ski according to DIN ISO standards on a

equipment is not available the ski can be mounted on a table (Picture 3.1 A).

2. Choose the correct drilling plate according to table 1. Models are mentioned on the drilling template.

table: 1

EaGLE / FREERiDE PRo

ExPERiEncE

In order to mount the bindings professionally, exactly and efficiently we strongly recommend using a steel drilling template.

3. Positioning of the drilling template: Measure or get the boot sole length from the boot. Place the drilling template so that the

corresponding length mark on the scale is aligned with the «mark on the ski» ▲ and clamp* or stick the drilling template flat onto

the ski (Picture 3.1 B).

If on the ski is only the boot tip position indicated, the point labelled «boot tip» has to be aligned with the mark on the ski (Picture 3.1 C).

* It is important that the steel drilling template lays flat on the ski and does not cant (Picture 3.1 D). If the drilling template can not

be opened wide enough for the ski (ski width < 94 mm), turn all rubber caps (Picture 3.1 E). Now the drilling template can be used

up to a ski width of 117 mm (Picture 3.1 F).

4. Use a step drill according to the ski manufacturer's instructions.

Ø 4.1 × 9 mm: mounting directly without tapping (Ø 3.6 × 9 mm for skis made of synthetic material).

Follow the ski manufacturer's instruction.

5. D rill through the correct holes up to the stop. With a steel drilling template drill through to the binding size corresponding bushes

(→ note the colour of the bushes) (Picture 3.1 G).

If you use a sticker drilling template, take a centre punch and mark guide holes in the surface of the ski corresponding exactly

with the marks for the mounting holes. remove the template before drilling (Picture 3.1 H).

6. Put a drop of glue into each hole before screwing the binding on in order to ensure a better fit and to prevent corrosion of the

screws.

Picture 3.1 a

Picture 3.1 E

3-point support

preventing the ski from moving when drilled and mounted. In case such

DRiLLinG tEMPLatE / StEEL

N° 002801

N° 002367

Picture 3.1 B

Picture 3.1 F

DRiLLinG tEMPLatE StickER

N° 002804

N° 002368

Picture 3.1 c

Picture 3.1 G

Picture 3.1 D

Picture 3.1 H