Miller XR Python 25 Ft. 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Miller XR Python 25 Ft.에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller XR Python 25 Ft. 31 페이지. 200 ampere push-pull welding gun
Miller XR Python 25 Ft.에 대해서도 마찬가지입니다: 소유자 매뉴얼 (24 페이지)

페이지 인쇄

1. Mechanical / Parts Lists

Section 3

Installation

Technical Specifications

Wire Capacity

Aluminum and Cored Wire ........................... .030" - 1/16" (0.8 mm - 1.6 mm)

Solid and Hard Wire ..................................... .030" - .045" (0.6 mm - 1.2 mm)

Wire Speed (At rated feeder input voltage) .............70 - 875 ipm (22.2 mpm)

Duty Cycle - 100% (All ratings are using Argon gas) ............ 200 Amps Peak

Shipping Weight (approximate) ...................................... 19.29 lbs. (8.29 Kg)

Gun weight (less leads)....................................................... 2.5 lbs. (1.13 Kg)

Support Equipment Required

•

Gun Lead Connections

Power Cable

A #2 AWG power cable is used on the XR™ Python

the cable has a fitting crimped to the copper cable strands. This fitting is

then threaded into the gun body. The cabinet end of the power cable is

incorporated into the Power Pin connector.

Conduit

The XR™ Python

aluminum wire. The longer fitting with a shallow groove is used on the gun

end. A set screw located on top of the gun handle secures the conduit in

place. The cabinet end of the conduit is incorporated into the Power Pin

connector.

Gas Hose

The gas hose is pushed over a barbed fitting on the gun body and secured

with a plastic tie wrap. The cabinet end of the gas hose is incorporated into

the Power Pin connector.

Electric Cable

A multi-conductor control cable is used on the XR™ Python

of the cable is secured with a cable clamp and the wires are connected to the

potentiometer, the micro switch, the motor and the gun body mechanically.

Slack is left in the electric cable as it exits the back of the gun to prevent

cable and/or wire breakage. The cabinet end of the control cable uses a 10-

Pin, "X" clocked Amphenol connector.

Section 4

Operation

General

The Python

regardless of curved or looped wire conduit. The constant push exerted

by the slave motor in the cabinet, combined with the pull of the gun motor,

C.V. or C.C. power source of sufficient capacity for your needs.

Regulated gas supply and hoses.

Properly sized power leads from power source to wire feeder and ground.

comes standard with a poly-lined conduit, for feeding

maintains a constant, steady, uniform wire feed speed,

XR™ Python

Owner's Manual - Page 1

. The gun end of

. The gun end