Miller SkyLine 70 운영자 매뉴얼 - 페이지 10

{카테고리_이름} Miller SkyLine 70에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller SkyLine 70 13 페이지. Fluid head
Miller SkyLine 70에 대해서도 마찬가지입니다: 운영자 매뉴얼 (13 페이지)

페이지 인쇄

Maintenance

The Skyline 70 Fluid Head offers high quality surface coatings.

Miller recommends keeping the Fluid Head clean at all times by

using soft brushes and lint free cloth to wipe over the surfaces.

• Do not immerse the Fluid Head in any liquid.

• Do not use stiff brushes, abrasives, harsh detergents and

solvents.

Battery Replacement

The Skyline 70 Fluid Head uses a single GP23A type - 12 Volt

battery for Illumination. Miller recommends the following batteries

to provide long life performance – GP23A, Duracell MN21/23 or

Vinnic L1028.

1 Using a Phillips Head #1 screw driver, remove the RETAINING

SCREWS and the BATTERY DOOR.

2 Using a small flat screw driver remove the battery.

3 Align the new battery as shown on the back of the BATTERY

DOOR and place into the BATTERY HOUSING, then push down

the battery into place. A small flat screw driver may be used to

push down the battery into the BATTERY HOUSING.

4 Align the BATTERY DOOR into the body then tighten the

screws lightly.

Battery

Illumination Button

Battery Housing

Battery Cover

Retaining Screws

Fig. 8