Miller Digital Performance Series 매뉴얼 - 페이지 3
{카테고리_이름} Miller Digital Performance Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Digital Performance Series 32 페이지. Auto-darkening helmets
Miller Digital Performance Series에 대해서도 마찬가지입니다: 매뉴얼 (28 페이지), 소유자 매뉴얼 (32 페이지)
페이지 인쇄
SECTION 1 − WELDING HELMET SAFETY PRECAUTIONS −
Protect yourself and others from injury — read, follow, and save these important safety
precautions and operating instructions.
1-1. Symbol Usage
DANGER! − Indicates a hazardous
situation which, if not avoided, will
result in death or serious injury. The
possible hazards are shown in the
adjoining symbols or explained in
the text.
Indicates a hazardous situation
which, if not avoided, could result in
death or serious injury. The possible
hazards are shown in the adjoining
symbols or explained in the text.
NOTICE − Indicates statements not related to
personal injury.
1-2. Arc Welding Hazards
Only qualified persons should install, operate, maintain, and repair this unit.
ARC RAYS can burn eyes and skin.
Arc rays from the welding process produce intense visible and invisible (ultraviolet
and infrared) rays that can burn eyes and skin. Sparks fly off from the weld.
D Wear a welding helmet fitted with a proper shade of filter to protect your face and eyes when
welding or watching (see ANSI Z49.1 and Z87.1 listed in Safety Standards). Refer to Lens
Shade Selection table in Section 1-4.
D Wear approved safety glasses with side shields under your helmet.
D Use protective screens or barriers to protect others from flash, glare, and sparks; warn
others not to watch the arc.
D Wear protective clothing made from durable, flame-resistant material (leather, heavy cotton,
and wool) and foot protection.
•
Before welding, adjust the auto-darkening lens sensitivity setting to meet the application.
•
Stop welding immediately if the auto-darkening lens does not darken when the arc is struck.
See the Owner's Manual for more information.
WELDING HELMETS do not provide unlimited eye, ear, and
face protection.
Arc rays from the welding process produce intense visible and invisible (ultraviolet
and infrared) rays that can burn eyes and skin. Sparks fly off from the weld.
D Use impact resistant safety spectacles or goggles and ear protection at all times when using
this welding helmet.
D Do not use this helmet while working with or around explosives or corrosive liquids.
D Do not weld in the overhead position while using this helmet.
D Inspect the auto-lens frequently. Immediately replace any scratched, cracked, or pitted cover
lenses or auto-lenses.
READ BEFORE USING
.
Indicates special instructions.
This group of symbols means Warning! Watch
Out! ELECTRIC SHOCK, MOVING PARTS,
and HOT PARTS hazards. Consult symbols
and related instructions below for necessary
actions to avoid the hazards.
helmet 2012−02
OM-256 476 Page 1