Miller Digital Performance Series 소유자 매뉴얼 - 페이지 13
{카테고리_이름} Miller Digital Performance Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller Digital Performance Series 32 페이지. Auto-darkening helmets
Miller Digital Performance Series에 대해서도 마찬가지입니다: 매뉴얼 (32 페이지), 매뉴얼 (28 페이지)
페이지 인쇄
1-1. Lens Delay Control
4-5.
Lens Delay Control
�
A Digital Elite lens is shown.
A Digital Elite lens is
1 Lens Delay Adjustment Buttons
shown.
2 Mode Control Button
1
Lens Delay Adjustment
Buttons
Use the Lens Delay Short and Long buttons
2
Mode Control Button
to adjust the time for the lens to switch to the
Use the Lens Delay Short
clear state after welding or cutting.
and Long buttons to adjust
The delay is particularly useful in eliminating
the time for the lens to switch
bright after-rays present in higher amperage
to the clear state after weld-
applications where the molten puddle re-
ing or cutting.
mains bright momentarily after welding. Use
The delay is particularly use-
the Lens Delay Control buttons to adjust de-
ful in
eliminating
lay from 0 to 10 (0.1 to 1.0 second).
after-rays present in higher
amperage
The delay ranges for each mode are as
where the molten puddle re-
follows:
mains bright momentarily
Weld, Cut, And X-Modes - No. 0–No. 10
after welding. Use the Lens
Delay Control buttons to ad-
just delay from 0 to 10 (0 1 to
The delay ranges for each
mode are as follows:
Weld, Cut, And X-Modes
0–10
Grind Mode
justment
bright
applications
1
Grind Mode- No delay adjustment
�
There is no lens delay adjustment in
the Grind mode, and in the Cut mode
(when sensitivity is set to 10).
�
X-Mode is not present on Performance
helmets.
Lens Delay Adjustment Procedure
No delay ad-
� Press Auto On/Off button to turn helmet
On.
� Press Mode button to select desired
function: Weld, Cut, or X-Mode.
There is no lens delay
adjustment in the Grind
� Use Short and Long adjustment buttons
to select desired delay.
mode, and in the Cut
mode (when sensitivity
� Begin welding or continue with other
is set to 10).
lens adjustments.
X Mode is not present on
2
Lens Delay Adjustment
Procedure
Press Auto On/Off but-
ton to turn helmet On.
Press Mode button to se-
lect desired function:
Weld, Cut, or X-Mode.
Use Short and Long ad-
justment
buttons
select desired delay.
Begin welding or contin-
ue
with
other
adjustments.
OM-256476 Page 1
OM-256476 Page 11
to
lens