Miller MP-10 Series 매뉴얼 - 페이지 8

{카테고리_이름} Miller MP-10 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller MP-10 Series 12 페이지. Passive welding helmets

페이지 인쇄
Miller MP-10 Series 매뉴얼

3-2. Replacing Lens and Lens Covers

!
Never use the helmet
without the inside
and
outside
covers
installed.
spatter will damage
the lens and void the
warranty.
1
Helmet Shell
2
Gasket
3
Outside Lens Cover
4
Spacer
5
Lens No. 10
OM-235 589 Page 6
1
6
7
lens
To remove the lens holding
properly
frame, push down on the
Welding
frame retaining arms and
push the retaining clips
outward. Lift the assembly
and pull free of the helmet.
To replace the outside lens
cover, push the cover to-
ward inside of helmet. Re-
move the rubber lens gas-
ket and install on new lens
4
3
2
Inside Lens Cover
Lens Holding Frame
7
6
5
cover. Reinstall the lens
holding frame.
.
Be sure the flat side of
lens
cover
gasket
faces the helmet shell.
To replace the inside lens
cover, remove the spacer
from the frame by pushing
up on the two top retaining
tabs. Replace lens cover
and reinstall the assembly
in the helmet.
805 051