Miller MP-10 Series Manual - Page 8

Browse online or download pdf Manual for Motorcycle Accessories Miller MP-10 Series. Miller MP-10 Series 12 pages. Passive welding helmets

Miller MP-10 Series Manual

3-2. Replacing Lens and Lens Covers

!
Never use the helmet
without the inside
and
outside
covers
installed.
spatter will damage
the lens and void the
warranty.
1
Helmet Shell
2
Gasket
3
Outside Lens Cover
4
Spacer
5
Lens No. 10
OM-235 589 Page 6
1
6
7
lens
To remove the lens holding
properly
frame, push down on the
Welding
frame retaining arms and
push the retaining clips
outward. Lift the assembly
and pull free of the helmet.
To replace the outside lens
cover, push the cover to-
ward inside of helmet. Re-
move the rubber lens gas-
ket and install on new lens
4
3
2
Inside Lens Cover
Lens Holding Frame
7
6
5
cover. Reinstall the lens
holding frame.
.
Be sure the flat side of
lens
cover
gasket
faces the helmet shell.
To replace the inside lens
cover, remove the spacer
from the frame by pushing
up on the two top retaining
tabs. Replace lens cover
and reinstall the assembly
in the helmet.
805 051