Miller T94i Series 매뉴얼 - 페이지 16

{카테고리_이름} Miller T94i Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Miller T94i Series 32 페이지. Auto-darkening helmets
Miller T94i Series에 대해서도 마찬가지입니다: 소유자 매뉴얼 (40 페이지)

페이지 인쇄

4-7. Sensitivity Control

Mode Button

Adjust Button

Increase (+) And

Decrease (-) Buttons

Use control to make the lens

more responsive to different

light levels in various welding

processes. Use a Mid-

Range or 30−50% sensitiv-

ity setting for most appli-

cations.

It may be necessary to adjust

helmet sensitivity to accom-

modate different lighting con-

ditions or if lens is flashing

On and Off.

The sensitivity ranges for

each mode are as follows:

Weld, Cut, X-Modes − 0 − 10

Stick Electrode

Short Circuiting (MIG)

Pulsed & Spray (MIG)

Gas Tungsten Arc (TIG)

Plasma Arc Cutting/Welding

OM-255503 Page 14

Grind Mode − No sensitivity

adjustment

Do not weld in the

Grind mode; the lens

will not darken.

Sensitivity

Procedure

Adjust helmet sensitivity

in lighting conditions hel-

met will be used in.

Press Mode (On/Off)

button to turn lens On.

Helmet control display

will appear.

Press Mode button to

select desired function:

Weld, Cut, or X-Mode.

Use the Adjust button to

select sensitivity, then

Recommended Sensitivity Settings

Mid-Range

Low/Mid-Range

Mid-Range

Mid/High-Range

Low/Mid-Range

Adjustment

Helmet is ready for use.

Slight readjustment may be

necessary for certain ap-

plications or if lens is flashing

on and off.

260482-4

use the +/− buttons to

adjust sensitivity to the

lowest setting.

Face the helmet in the di-

rection of use, exposing

it to the surrounding light

conditions.

Press + button until the

lens darkens, then press

− button until lens clears.

Reduce Sensitivity set-

ting if lens stays dark

longer than Delay set-

ting.